Begin thoroughly rinsing your wheels with a pressure washer. The aim here is to remove as much of the dirt and grime without touching the wheels. If you don’t have a pressure washer, you can do this part with a conventional hosepipe but it’ll be much less effective. The PRO-KLEEN TROLL’S BREATH immediately begins to turn a deep purple colour as it gets to work dissolving the brake dust particles. The more purple it goes, the more iron fallout is on the wheels. It naturally “pulls” in a downward direction under gravity, pulling iron contamination away from the wheels. The solution was easily sprayed onto the wheels and needed time to soak into the baked-on brake dust. To simply leave and rinse in all fairness would not completely clean off any long term “baked on” brake dust and I would be forced to re-apply or work hard with a soft brush to break under the sealed layer of brake pad debris. The “debris” is caused by a build-up of fine brake pad particles. Under the heat of braking, these particles get baked onto the alloy surface. At first, this isn’t too noticeable, but over time it’ll start to show up as a dark grey film known as iron fallout which is nearly impossible to wash off with car shampoo. When not in use, ensure sprayer nozzle has been returned to closed position to prevent evaporation and leakage of product. Store product upright in a cool dry place, out of direct sunlight. Like all iron-reactive cleaners, Dragon Blood does have a strong odour and should be used in a well ventilated area.

Any ideas on which fallout remover to go for? Been looking at something called aliens blood, trolls breath by proclean, as well as one called gtechniq w6? Spray the gel/liquid formula directly on to your wheels. Allow the product to settle and dwell for approximately 5-10 minutes. Once the liquid has changed from clear to a shade of purple then rinse the wheels clean with warm water. If necessary, reapply the solution again and agitate with a soft brush. The Car Gods 54 Fall Out Eliminator is a pH balanced and silicone free formula that’s suitable for use upon paint, metal, glass, plastic and other trim. The brand state that you simply need to apply a generous amount to the surface, allow 5 minutes for the formula to turn completely purple and then rinse clear.The penultimate step is to thoroughly rinse your wheels. Be sure to get all of the wheel cleaner completely removed, you don’t want this to sit on the wheels and start to dry on the surface.

Dragon Blood is safe on most wheel types, however we always suggest doing a small test patch when trying on a new wheel surface. While these products have been extensively tested in a variety of different scenarios there are a multitude of wheel finishes used in the aftermarket and OEM*Working from the top of the wheel downwards, begin spraying on your wheel cleaner being sure to follow the manufacturer instructions. Don’t be too worried about using too much wheel cleaner, ensure that all parts of the wheel have been sprayed. Allow to dwell on the surface for 5 minutes or so. Don’t let dull, grimy alloys drag your car down. Use the power of the Dragon to get your wheel trims looking pristine – it’s pH neutral so you can use it on all kinds of alloys, paintwork, and glass, too! How to Use Dragon’s Blood Whilst it’s possible to clean your wheels without a pressure washer, we strong advise using one. A pressure washer will provide much more cleaning power and make the job a whole lot easier. The product was then liberally sprayed onto the bodywork of the vehicle and began its process of dissolving over three months of grime, dirt, bird droppings and the like, effortlessly. The vehicle was once again rinsed with a hose to neutralise the solution and helped prep the car for the next stage of the detailing process, Snow Foam.