10 Pieces RETAINING R CLIPS PINS TO SUIT BRAKE DISC PAD (SMALL) CLIP CALIPER PMBR6 (10)

Product Information

Ans: The new brake pads come with new clips. The clips that come with the new brake pads are specific to either the right side or left. So, in case of installation, you have to make sure to install it on the appropriate side. Always replace old clips.

Lower the Vehicle: Lower the vehicle to the ground and make sure it’s level before testing the brakes. Make sure any debris or oils are removed from surrounding areas so that your new clips look their best when they’re installed later on. Mark Your Pad’s Location Test the Brakes: Before driving, gently press the brake pedal a few times to restore the proper position of the brake pads. Take your vehicle for a short test drive to ensure that the brakes are functioning smoothly and without any unusual noises.To remove the brake pad retaining clip, first, locate it on the front of your brake pads. Next, use a flathead screwdriver to pry off the surface of the clip until it pops free from your brakes. Clean Up Any Surrounding Area This is how the anti-rattle clip protects the brake pads and ensures a safer and more effective braking system. 5. For Enhancing the Longevity of Brake Pads

Congratulations! You’ve successfully installed new brake pad retaining clips and brake pads. This essential maintenance task will not only enhance the safety of your vehicle but also improve its braking performance. Enjoy your renewed peace of mind and confident stops on the road. How to Install Rear Brake Pads

But if you hear a rattle when you brake, it’s something that’s maybe supposed to be a rubber bushing that’s worn out. Clip Inspection: Examine the condition of the existing brake pad retaining clips. If they are worn or damaged, remove them using a screwdriver or a suitable tool. There are different designs for these clips, depending on what works best for your car and braking system. Basic Installation Steps: The basic steps for installing rear brake pad retaining clips are similar to the front. You will still need to remove the caliper, replace the pads, and ensure proper lubrication and alignment. Finally, reattach the tab securing handle if present then takes care when walking away from a car that the brakes won’t work. Problems of Having Bad Brake Pad Retaining Clips

Depending on your vehicle’s brake system, you may need to bleed the brakes after installing the rear pads. This step removes air from the brake lines and ensures optimal brake performance.The brake pad retaining clip is a small metal clip that attaches to the front of your brake pads and holds them in place. The most common brake system is hydraulic, which uses fluid pressure to push brake pads against the rotors, create friction, and slow the vehicle. Parking Brake: Rear brake systems often incorporate a parking brake mechanism, which can affect the installation process. Ensure the parking brake is disengaged before working on the rear brakes. A properly installed anti-rattle clip really gives you a great brake experience. How to Install Anti rattle Clips [5 Steps]