Dremel 566 Tile Cutting Kit, Accessory Set with Cutting Guide and Spiral Cutting Bit for Precision Cuts in Wall Tiles

Product Information

Now that you have made the lines, the next step is securing the tile to the bench. It is recommended that you use rubber clamps as they can hold the tile firmly without marking or breaking the tile itself. If you do not have rubber clamps, place some tissue between the tile and clamp so that no marks are made. The process of cutting tiles with a Dremel requires careful preparation, setting the correct tool speed, and proper cooling of the cutting wheel to prevent overheating. Safety is paramount when working with power tools such as a Dremel, particularly when cutting hard materials like tiles. There will be a lot of fine dust particles generated when you cut the tile and spinning wheel could potentially send small fragments flying, so be sure that your safety gear is on properly. Practice First: If you’re new to using a Dremel for tile cutting, try practicing on an old or spare tile first. This gives you a chance to familiarize yourself with the process without risking any of your project tiles.

Once the grinding attachment is securely in place, gently run it along the cut edges of your tile. This will help to smooth any rough edges and corners that your original cut created. I suggest you use one of the more powerful corded Dremel tools, such as the Dremel 3000 or 4000. That has the power to make the cuts cleanly when combined with the diamond wheel. Less powerful Dremel tools, such as the Stylo+ are not sufficient to make cuts into tile. Tools Needed Prevent Skidding: To keep the Dremel from slipping when you start your cut, make a small notch at the start of the cut line. I like to scribe with a glass cutter. This gives the cutting wheel a ‘groove’ to sit in and makes it easier to start the cut.

Similar products

A higher speed – generally around 20,000 to 25,000 (RPM) – provides a cleaner, more efficient cut. This is because the faster spinning action of the diamond wheel at high speed more effectively grinds through the hard tile material. You can mark all the tiles that you want to cut first before going to the next step or follow the steps one tile at a time; it is your choice. 2. Clamping Tile to Surface It helps if you cut the tile in a well-ventilated area, such as outdoors, with the garage door open, or with a fan running to circulate the air. This helps disperse dust and keeps your working environment cleaner and safer. 6. Cooling the Cutting Wheel Cleaning Up: After you’ve finished cutting, remember to clean your Dremel thoroughly with a shop vac. Tile cutting can leave dust and tiny fragments that may affect the performance of your Dremel tool over time.

You can raise the RPMs even higher, but the tool will create a high-pitched noise that may be distracting. If you have ear protection, you may want to set it higher, but 20000 RPMs is generally good enough for ceramic tile. However, feel free to experiment with scrap tile to find the speed that works best for you. 5. Put On the Safety GearYou could also have a bowl of water and dip the cutting wheel in the water to cool it down. Just be sure not to splash or pour the water on the Dremel itself. 7. Creating Straight & Curved Cuts Use Plunge Cuts to create holes for electrical outlets on wall tiles. Using a Right Angle Attachment makes this task easier. A Dremel, when equipped with a diamond cutting wheel, is capable of cutting through hard materials like ceramic and porcelain tiles.