Having the packer it will bring the drawer away from hinge or door so when in use it does not hit either door or hinge when the door is fully open.

The 200 kg evenly distributed load applies if the drawer slides are used standing, or mounted against a side. Available with ball bearing or telescopic mechanisms, these runners are available for a variety of drawers including kitchen drawer runners for both domestic and commercial use, cabinets, and bedroom furniture.Whether our drawer will be roomy, functional and practical depends primarily on the type and quality of the drawer runners. This small detail allows the drawer to bear more weight and will prevent it from sagging compared to mounting the slides deeper into the cabinet, further away from the front of the drawer. This applies in both retracted and extended position and if the weight is evenly distributed over the length. It's essential to ensure that the space between the drawer and the cabinet's side walls is exactly the same as the thickness (19mm) of these slides.

If the gaps are too large, especially installed in vehicles, the drawer gets wobbled sideways, which can cause permanent damage. A set includes a left and a right drawer slide of which only the handle differs; of one guide the handle points upwards, of the other downwards. When selecting drawer runners factors such as the intended load capacity, desired extension range, and overall quality should be considered to ensure optimal performance and durability. Nevertheless, they are also often used in the production of large home furniture such as built-in wardrobes. If you opt for the latter, make sure to use a thread diameter of up to 5mm so that the countersunk head partly fits into the hole.We distinguish between ball and roller guides, but for large furniture, only heavy-duty ball bearing drawer runners (900mm) are usually used. This small detail allows the drawer to be loaded more heavily and will deflect less than if you were to mount the guides deeper into the casing, i. The balls fix the drawer from all sides, preventing it from bouncing up and down in a camper, for example. If the drawer needs packers the drawer will be cut either 25mm shorter in width or 50mm shorter in width according to if you need a packer one side of the drawer or both sides. There are no sharp wire ends protruding anywhere, so that the brackets can be placed close to a wall.